Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX3 MANUFACTURING QUESTION

Thread starter EngMfg1
Start date Apr 19, 2005

Status: Not open for further replies.

Apr 19, 2005

EngMfg1

Aerospace

HI EVERYONE

I am trying to use a 90deg head on a horizontal machine with the spindle of the angle head face the machine table, I notice that when creating tools in NX3 there are 3 new subtypes for all mill types CARRIER, POCKET, HEAD, does anyone know if the head subtype is used for right angled heads and if so does anyone know how to use it.

If anyone can help with this it would be greatly appreciated

Thanks All