NX10 Simple Clearance Check

[scmorris]

In NX 7.5 there was a menu

Analysis - Assembly Clearance - Simple Clearance Check

which was very handy quick way to do a check on an assembly. Can't find this option in NX10. Is it still there?

thanks

Steve

 

[studiotreccani]

ofcourse is still there:
use command finder: clearance analysis
or go to analysis->assembly clearance...


NX 7.5 64bit
NX 9.0.3.4 MP4 64bit

http://www.studiotreccani.com

 

[scmorris]

In NX7.5 there were 3 ways to check for assembly clashes/clearances:

Analysis - simple interference
Analysis - Assembly Clearance - Simple Clearance Check
Analysis - Assembly Clearance - Clearance Set

The second one is now gone in NX10 and the others are still there.

thanks

Steve