Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX10 member of a part family : properties

Status
Not open for further replies.

andyniktutby

Bioengineer
Joined
Aug 17, 2015
Messages
7
Location
BY
Hi everyone,
I have some problems with properties of a single member from part family (NX siemens 10).

When I make assembly of tubes and tees in routing mechanical mode and then insert this assembly into another assembly, I cannot see the properties of single tee part from final assembly. All properties are written in *.ptb file and come into first assembly during "place part" operation as part characteristics and possible to see by properties.

Does anyone know how to inherit the properties from first assembly to final?

Thanks
 
try the Siemens UG NX forum

Hydrae
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top