Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX Sheet metal material attribute

Thread starter Lars1978
Start date Mar 7, 2016

Status: Not open for further replies.

Mar 7, 2016

Lars1978

Mechanical

Hi All,

I found a thread regarding the sheet metal material attribute. (It was not possible to extract the Sheet metal material attribute. You had to use the material attribute out of the modeling environment.)

Is it already possible to link this sheet metal material attribute to a field in the draft?

Kind regards,

Lars

NX 10 mach adv.
Native