Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX 9 Creating Manual Balloons that doesn't update with Part List
- Thread starter n2design
- Start date
If you attach a balloon leader to the edge of a component, it will update with information about that component.
Here's a work-around:
Create an associative point on the edge of interest and attach the ID symbol to the point rather than to the edge. The balloon will not update with the parts list as it is not pointing at a component, but it will update position if/when the view moves.
www.nxjournaling.com
Here's a work-around:
Create an associative point on the edge of interest and attach the ID symbol to the point rather than to the edge. The balloon will not update with the parts list as it is not pointing at a component, but it will update position if/when the view moves.
www.nxjournaling.com
- Thread starter
- #4
- Status