Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 8.5 (w/Tc 9.1) importing Fonts (TrueType)

Thread starter MarkGibson
Start date Jan 12, 2016

Status: Not open for further replies.

Jan 12, 2016

MarkGibson

Mechanical

Greetings all,

Specific to NX 8.5 (using Tc 9.1 on back end), I am interested in importing fonts into NX PMI and NX Drafting and was wondering if anyone can attest to the success (or failures, challenges/issues) of importing TrueType font files and/or OpenType CFF font files from the following applications: 1) FontLab, 2) FontForge ?

I seen some postings from JohnRBaker regarding another 3rd party software but not sure of its viability relative to the 2 above that I mentioned.

Thanks,
Mark