aleksandar81
Mechanical
- Jul 2, 2014
- 137
I have some problems with turning.
1.I'm trying to reduce radial safe clearance value for tool retracting from the cut, (non cutting moves/clearance/workpiece clearance) but minimum tool clearance is 1mm even when I add radial safe clearance value 0mm, OD and ID cutting.
2.Even when I add trim planes for some reason tool is gouging into the part.
3.In cone grooving when I check additional profiling and pick diameters first, then faces, or something else, nothing happens cutting parameters are not taken into the account?
1.I'm trying to reduce radial safe clearance value for tool retracting from the cut, (non cutting moves/clearance/workpiece clearance) but minimum tool clearance is 1mm even when I add radial safe clearance value 0mm, OD and ID cutting.
2.Even when I add trim planes for some reason tool is gouging into the part.
3.In cone grooving when I check additional profiling and pick diameters first, then faces, or something else, nothing happens cutting parameters are not taken into the account?
