Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 8.5 Ordinate dimension issue

Thread starter Shankarch21
Start date Aug 31, 2016

Status: Not open for further replies.

Aug 31, 2016

Shankarch21

Mechanical

Hi,
Can anybody help me to set the ordinate dimensions in NX 8.5. After creating origin, when I try to create ordinate dimension, by default am getting additional dimension line with small origin symbol. I struggled to off this dimension line but could not succeed. Can you please help me.