ableakley
Mechanical
- Aug 15, 2014
- 5
Hi,
Is there anyone out there that can give me any tips or help with regards to formboards on NX 8.5? I know this isn't specific, but I made a specific post a while back and it got no replies. Basically, I'm trying to put elecrtical harnesses on to a formboard to show true wire lengths in 2D such that they can be drafted from it.
Currently, I can get the harnesses on to the formboards but if there is multiple wires coming from/leading to some components it gets very messy and the wires aren't shown straight and of their true lengths. If there is just one wire or so from each component, though, it seems to be working fine.
Like I said, any advice at all will be helpful.
Cheers,
Alex
Is there anyone out there that can give me any tips or help with regards to formboards on NX 8.5? I know this isn't specific, but I made a specific post a while back and it got no replies. Basically, I'm trying to put elecrtical harnesses on to a formboard to show true wire lengths in 2D such that they can be drafted from it.
Currently, I can get the harnesses on to the formboards but if there is multiple wires coming from/leading to some components it gets very messy and the wires aren't shown straight and of their true lengths. If there is just one wire or so from each component, though, it seems to be working fine.
Like I said, any advice at all will be helpful.
Cheers,
Alex