Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 8.5 - 3-D Centerline Issue

Status
Not open for further replies.

ARToolingEngineer

Aerospace
Joined
May 11, 2021
Messages
52
Location
US
Greetings:

I am drafting a part, and created a section view to expose specific holes that I want to describe from within the section. When I select 3-D Centerline, the holes are not recognized to place the centerline. Am I doing something incorrect?

Thanks,

Brent
 
3D CL works for me in a section view.
Make sure the section is taken exactly down the hole centers, and not at a slight angle off.

Jerry J.
UGV5-NX1961
 
Ok, got it. It was an old file, so not exactly through the center could have been the issue. I replaced the entire section and 3-D Centerline worked fine.

Thank you for the reply,

Brent
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top