shidinghao
Electrical
Hi,
I just have a quick question about motion simulation. I'm new to it, and just play with it to make some animation for fun. What I was trying to do was a simple revolute(with a pin and a link). However, the revolute and screw in my joint drop-down are grey, I was wondering how would that happen? I followed a tutorial, and it works fine on the screen. Below is a picture I attached.
Thanks.
img ]
I just have a quick question about motion simulation. I'm new to it, and just play with it to make some animation for fun. What I was trying to do was a simple revolute(with a pin and a link). However, the revolute and screw in my joint drop-down are grey, I was wondering how would that happen? I followed a tutorial, and it works fine on the screen. Below is a picture I attached.
Thanks.
img ]
