Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
nx 6 returns to gateway after replaying a journal
- Thread starter lklo
- Start date
JohnRBaker
Mechanical
What exactly are you doing in your journal? I just performed a test using NX 6.0.5.3 where starting in Modeling, I created a Block feature and then edited one of it's parameters. When I ran the journal it did just that and left me in Modeling, as I expected it to.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #3
- Status
