Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 1919 Hole Table - Missing Holes On the Table

Status
Not open for further replies.
A.Cole

A.Cole

Automotive
Joined
Jun 12, 2020
Messages
11
Location
US
Hey All,

I'm putting in a hole table and after selecting my origin and holes, and the hole table comes in, it has about half of my holes called out.
Calls out P, F, G, and H.....but I've also got A, B, N, M...etc...
They all start on the same plane, and they were made with a combination of the hole command and linked bodies.

Anybody else encounter this and find the issue?

Thanks in advanced!
 
Status
Not open for further replies.

Similar threads

johnny777886
  • Locked
  • Question Question
NX2206 Hole Table Numbers Reset
Replies
0
Views
379
johnny777886
johnny777886
shightower
  • Locked
  • Question Question
Countersink on both sides of hole in NX?
Replies
3
Views
2K
Bleaker
Bleaker
MANox
  • Locked
  • Question Question
Number of holes in Hole and thread callout
Replies
0
Views
1K
MANox
MANox
Jashe
  • Question Question
How to create Radial Section Cut on NX Drawing
Replies
5
Views
11K
SDETERS
SDETERS
G
  • Question Question
NX Journal
Replies
15
Views
28K
Toost
Toost

Part and Inventory Search

Sponsor

Back
Top