Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 1919 Hole Table - Missing Holes On the Table

Thread starter A.Cole
Start date Sep 23, 2021

Status: Not open for further replies.

Sep 23, 2021

A.Cole

Automotive

Hey All,

I'm putting in a hole table and after selecting my origin and holes, and the hole table comes in, it has about half of my holes called out.
Calls out P, F, G, and H.....but I've also got A, B, N, M...etc...
They all start on the same plane, and they were made with a combination of the hole command and linked bodies.

Anybody else encounter this and find the issue?

Thanks in advanced!