Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations Ron247 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Number of sheets as an expression in UG

Thread starter ARCain
Start date Mar 14, 2016

Status: Not open for further replies.

Mar 14, 2016

ARCain

Mechanical

Hi all,

Is there an equivalent of <W@$SH_NUMBER_OF_SHEETS> that will allow me to save the number of sheets in a drawing as a variable? I would like to make a revision block on my drawing sheet template that is made from a linear pattern of a cell displayed X number of times, where X is the total number of sheets in the drawing.

Thanks!