maverick118
Mechanical
Please can anyone advise me on thread form for a 1.500 inch 14 NS-2A thread
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NS -2A thread forms
- Thread starter maverick118
- Start date
- Status
As far as I know, the thread form is the same as Unified series - UNC, UNF, etc. 60 degree included angle.
Manufacturing Freeware and Shareware
Manufacturing Freeware and Shareware
My old handbook has this same table. You will note that there is an additional TPI call out for the NS say:
1/4-NC/UNC 20; NF/UNF28; NEF/UNEF 32; while the NS/UNS is 24.
1/4-NC/UNC 20; NF/UNF28; NEF/UNEF 32; while the NS/UNS is 24.
- Status
