Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

nozzles in FTCO

Status
Not open for further replies.
yosamitysamm

yosamitysamm

Mechanical
Joined
Apr 1, 2009
Messages
28
Location
CA
Hi Everyone,

I have been requested to install a 3" nozzle into a FTCO and I have a couple of questions.

1. As per API 650 sect 5.8.3.4 the nozzle size is limited to 2" and points you to sect 5.8.3.1 for guidlines. This section is for unreinforced openings. Does this mean you could go with a larger nozzle (3") if you were to add reinforcement?

2. One of my FTCO has already been built, tested and PWHT. Would the cover have to be PWHT again after the nozzle weas installed? The cover thickness is 1 1/4".

Thanks for any comments.
 
Status
Not open for further replies.

Similar threads

QA -Ernesto
  • Locked
  • Question Question
Storage tank new nozzles install
Replies
2
Views
544
QA -Ernesto
QA -Ernesto
tankinspector88
  • Locked
  • Question Question
Weldability of a API-650 tank constructed in 1980
Replies
5
Views
2K
FacEngrPE
FacEngrPE
myname_earl
  • Locked
  • Question Question
API 510 - In-Service, Out-of-Service Clarification
Replies
2
Views
1K
myname_earl
myname_earl
WissamH
  • Locked
  • Question Question
Guidelines for Selecting the Freeboard in Ground Storage Tanks
Replies
16
Views
3K
WissamH
WissamH
jfacevedob
  • Locked
  • Question Question
Diameter limitation for SS anchor bolt in API 650 tanks
Replies
2
Views
2K
IFRs
IFRs

Part and Inventory Search

Sponsor

Back
Top