Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Nozzle Joint Design ASME Sec VIII Div 1 1

Status
Not open for further replies.
wagnermj

wagnermj

Chemical
Joined
Mar 17, 2010
Messages
15
Location
US
Does anyone know where I can find acceptable joint designs for nozzle penetrations through flat heads (i.e. 1" nozzle to 10" 300# RFBF). I am not sure if UW-16 applies to this application.
 
Sort by date Sort by votes
UW-16(a)(1)

Regards,

Mike
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

G
  • Locked
  • Question Question
Stainless Steel for ASME BPVC VIII
Replies
3
Views
4K
Andy Mayfield
A
wontweldcantweld
  • Locked
  • Question Question
ASME IX - Can a lower SMYS cover a higher SYMS?
Replies
0
Views
321
wontweldcantweld
wontweldcantweld
PS.Material
  • Locked
  • Question Question
Application of WB 384 1.8807 as Boiler Drum Material in ASME Section I
Replies
2
Views
426
MJCronin
MJCronin
rideHPD
  • Locked
  • Question Question
1/4, 1/2 Hard 316 Sheet, Availability/Experience?
Replies
8
Views
1K
TugboatEng
TugboatEng
bryansonnier
  • Locked
  • Question Question
ASME A216 WCB Stress Strain Curve
Replies
1
Views
459
bobjustbob
bobjustbob

Part and Inventory Search

Sponsor

Back
Top