Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

North American equivalence to "standard NF EN 10051"

Status
Not open for further replies.
thierryhcnguyen

thierryhcnguyen

Materials
Joined
Nov 10, 2010
Messages
3
Hi
the NF EN 10051 specifies tolerances for steel product in France.
I am looking for an equivalence in North America.
Does anyone know ?

Regards
 
Status
Not open for further replies.

Similar threads

MujtabaQA
  • Locked
  • Question Question
Who can explain about Thin-wall pipe as per ASTM standard
Replies
6
Views
2K
EdStainless
EdStainless
Mike Mike
  • Locked
  • Question Question
Am I supposed to specify mortar type M, S, N, or O?
Replies
9
Views
3K
phamENG
phamENG
Muza33
  • Locked
  • Question Question
heating rate applicable for normalisation of Dish end for pressure vessel
Replies
0
Views
740
Muza33
Muza33
ranidasps
  • Locked
  • Question Question
standard of ERW Fitting
Replies
1
Views
251
MJCronin
MJCronin
Tmoose
  • Locked
  • Question Question
"Tee" section straightness and sweep completely set forth in ASTM A6
Replies
2
Views
587
phamENG
phamENG

Part and Inventory Search

Sponsor

Back
Top