Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Norms to metrics drawing 1
- Thread starter SunVV
- Start date
-
1
- #2
You could always do a search on this forum, or on the ISO site:
You're probably looking for ISO 2768
Good Luck
johnwm
________________________________________________________
To get the best from these forums read faq731-376 before posting
Steam Engine enthusiasts:
You're probably looking for ISO 2768
Good Luck
johnwm
________________________________________________________
To get the best from these forums read faq731-376 before posting
Steam Engine enthusiasts:
What aspect of the drawing do you want to ISO specs?
2768 deals with dimensioning.
Others deal with GD&T, drawing formats, etc.
"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
2768 deals with dimensioning.
Others deal with GD&T, drawing formats, etc.
"Wildfires are dangerous, hard to control, and economically catastrophic."
"Fixed in the next release" should replace "Product First" as the PTC slogan.
Ben Loosli
CAD/CAM System Analyst
Ingersoll-Rand
jsummerfield
Electrical
NIST Special Publication 330
NIST Special Publication 811
40334 Federal Register / Vol. 63, No. 144 / Tuesday, July 28, 1998 / Notices
IEEE/ASTM SI 10™-2002 American National Standard for
Use of the International System of Units
(SI): The Modern Metric System
John
NIST Special Publication 811
40334 Federal Register / Vol. 63, No. 144 / Tuesday, July 28, 1998 / Notices
IEEE/ASTM SI 10™-2002 American National Standard for
Use of the International System of Units
(SI): The Modern Metric System
John
- Status
Similar threads
- Locked
- Question
