Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

noob nurbs question

Status
Not open for further replies.

helicase

Automotive
Joined
Mar 19, 2013
Messages
1
Location
US
Tertiary surface's ... do I make them G1, G2, or G3? They are so small, and i'm thinking sheet metal presses tolerances from spring back from the elastic deformation will cancel out any fine tuning with these surfaces, so is it safe to make them G1? Thanks for the help!!!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top