Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Non-planar 2d curves
- Thread starter W3S
- Start date
Create an empty part
Create your plane
Move or align your curves to that plane
You may have to move them away from the plane then back again
Then "attach" the curves to the part
Then you should be able to sketch on that plane and constrain and dimension the curves.
Create your plane
Move or align your curves to that plane
You may have to move them away from the plane then back again
Then "attach" the curves to the part
Then you should be able to sketch on that plane and constrain and dimension the curves.
- Status