Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

no design for steel beam

Status
Not open for further replies.

shijie0411

Structural
Dec 11, 2011
8
Hi everyone,
I am pretty new in etabs and in steel structure design, but I tried several times using etabs doing analysis and design of simple supported steel beam, I usually use auto selection list letting the program decide the proper section for the member, it worked before. I am trying to model a single story buidling this time, for the beams I still use autoselection list, but when I performed design for steel frame, it looks like no design result comes out for all the steel beams, can anybody find out the reason and help me out please?
Please see attached model.
Thank you.
 
Replies continue below

Recommended for you

It's good to know. Thank you very much!
Regards,
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor