M
MarkoSiroki
Guest
Hi to all!
I had two sketches with solely center lines. In the first sketch, I had centerline pointing intersection of my shape, the other sketch was pointing to edges of same shape. I merged via copy-paste these two sketches into single sketch, called "Center Lines". But, I cannot exit sketch mode, since solidworks constantly shows that skestch is under defined. I've corrected all relations in new sketch, added smart dimensions but still no result. What am I missing?
Sinceely yours,
Marko
I had two sketches with solely center lines. In the first sketch, I had centerline pointing intersection of my shape, the other sketch was pointing to edges of same shape. I merged via copy-paste these two sketches into single sketch, called "Center Lines". But, I cannot exit sketch mode, since solidworks constantly shows that skestch is under defined. I've corrected all relations in new sketch, added smart dimensions but still no result. What am I missing?
Sinceely yours,
Marko
