Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Newb Question

  • Thread starter Thread starter boardmda
  • Start date Start date
B

boardmda

Guest
Hi,

I’m just getting into this for my business. I’m looking for some help regarding a ring. I want to be able to change the ring size for this ring. Any help would be greatly appreciated. File was created with Solidworks. I do have both Rhino and Solidworks.

Thanks for your time.

Ring.SLDPRT
 
You must log in or register to reply here.

Similar threads

E
New to the forum, question about a pin and slider joint
Replies
0
Views
6K
EightballRider8
E
Jack Henriques
  • Locked
  • Question Question
Question for any MEs working on PCB designs
Replies
0
Views
249
Jack Henriques
Jack Henriques
cbell1007
  • Locked
  • Question Question
BILL OF MATERIALS QUESTION- for assemblies w/ sub-assemblies
Replies
4
Views
305
mflayler
mflayler
321GO
  • Locked
  • Question Question
Sheetmetal question: pressed sheetmetal parts ?
Replies
13
Views
480
321GO
321GO
bd9607
  • Locked
  • Question Question
two questions: Sending models and memory
Replies
2
Views
226
bd9607
bd9607

Part and Inventory Search

Sponsor

Back
Top