hi, im a new solidworks user who has just come on board after 10 plus years of cadkey. i can't figure out how to get the bend deductions to work. i model a simple l-bracket at 3" x 3" and then flatten it. we assigned a .114 bend deduction as that is our standard for .048 18 gauge stainless and we get a flat pattern at 6" with no deduction taken. what am i doing wrong?
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
new user needs help
- Thread starter dcass
- Start date
![[cheers]](/data/assets/smilies/cheers.gif "[cheers] [cheers]")
Look at the help on this in SW. It's very detailed.
Regards,
Scott Baugh, CSWP![[pc2]](/data/assets/smilies/pc2.gif "[pc2] [pc2]")
3DVision Technologies
faq731-376
faq559-716 - SW Fora Users
Regards,
Scott Baugh, CSWP
3DVision Technologies
faq731-376
faq559-716 - SW Fora Users
- Status
Similar threads
- Locked
- Question
- Locked
- Solved