my company just got a fbb robot welder and I have been elected to program it so far my biggest problem is warped metal it is either raised or lowered at the point of welds is there a trick or some command to comp for this like I said im new to this and have very limited knowledge
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
new to robotics
- Thread starter davidc333
- Start date
ABB probably has sensors available to follow the contour. Look on YouTube.
Other than that, spend a lot of time on the phone with ABB, your boss for not getting you trained, and maybe brush up your resume as buying a complex tool without training or determining suitability for the job seems like a recipe for a failed company.
Other than that, spend a lot of time on the phone with ABB, your boss for not getting you trained, and maybe brush up your resume as buying a complex tool without training or determining suitability for the job seems like a recipe for a failed company.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question