Network Design 1

[DimoS]

Hi all,

I was wondering is it possible to design a communications network (with nodes connected with each other) and run some algorithms on it.

Is simulink to be used or u need the neural network toolbox.

I would apreciate any anwers

thank you

 

[Lewish]

Since you obviously know nothing about Matlab, I will try to help that. All toolboxes require Simulink to be useable.
From the limited information for what you are describing, I would suggest that you take a look at the Communications Toolbox and see how it might fit your desires.

 

[DimoS]

Thank you

Tried it but cant find how to represent nodes and weighted lines to connect them in it.

As u already pointed out i am not good in matlab but i try to learn.

Any help is much appreciated.

Thank you again