tomwalz
Materials
- May 29, 2002
- 947
Need small, simple stage to adjust a paste dispensing head.
Total weight to be supported is three pounds. Need maybe one inch up and down (vertical) and two inches in and out (horizontal. We only need fractional accuracy 1/32” and manual control.
This is all we need and we don’t really want to pay for anything more than we need.
McMaster has driven linear slide assemblies starting at $200 for one direction. We figure maybe $100 to $150 for a unit to give us both directions.
We would appreciate any help you can give.
Tom
Total weight to be supported is three pounds. Need maybe one inch up and down (vertical) and two inches in and out (horizontal. We only need fractional accuracy 1/32” and manual control.
This is all we need and we don’t really want to pay for anything more than we need.
McMaster has driven linear slide assemblies starting at $200 for one direction. We figure maybe $100 to $150 for a unit to give us both directions.
We would appreciate any help you can give.
Tom
