Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need Help 1

Status
Not open for further replies.

djpeterlewis

Electrical
Joined
Feb 19, 2008
Messages
2
Location
ZA
Hi all

I am looking for someone who can draw a circular sheet of aluminimum 5mm thick and place 4 slots on a specific part of the plate and then using the pattern feature or mirror feature copy these 4 slots 50x in a circular direction

If you can help I would appreciate it , i am new to Solid Edge v19

Thanks

Peter



 
Sorry, Just to give you an idea what I am looking to do

The circular plate is 560m diameter and there must be 52 of the Holders around this plate.

Please find my version of the holder and the plate and my attempt to assemble on the site in a rar file
I have already tried to assemble them but my knowledge is limited


Thanks for your help in advance
 
Hi,

attached find the completed assembly. I've changed
the angle of the holder's flange otherwise they would interfere
with each other on assembly. There is still some room for
improvement. I've not included your original parts.
The cutout on the angled flange is done by modification
of the flange's profile after it has been created. The lower
tabs are created by cutout.

HTH

dy
 
 http://files.engineering.com/getfile.aspx?folder=4283b99f-8b8f-4a9d-a281-ca75f2728208&file=Holder_V19.zip
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top