Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need Help with Thread Type 1

Status
Not open for further replies.
sg20

sg20

Mechanical
Joined
Mar 8, 2005
Messages
117
Location
US
I have a part from a customer measured either .625-24 standard or 15.87 x 1.0 in metric. Is this a special type of thread; because I don't see it in the basic thread chart. Thanks in advance for your help.
 
Sort by date Sort by votes
5/8-24 is a UNEF thread size.

Reidh
 
Upvote 0 Downvote
Thanks Reidh,

sg20
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Locked
  • Question Question
Vibration excitation with electromagnet
Replies
11
Views
6K
acoustic67
A
Sparky4598
  • Question Question
Balancing large 8600hp electric motor with fluid film bearings
Replies
18
Views
9K
mfgenggear
mfgenggear
kwisatz_haderach
  • Locked
  • Question Question
Help identifying the source of vibration
Replies
10
Views
1K
electricpete
electricpete
buffoon1
  • Locked
  • Question Question
Identify type of component producing this noise?
Replies
2
Views
415
buffoon1
buffoon1
Mech Sundaram
  • Locked
  • Question Question
A vibrator table is there with two
Replies
2
Views
434
IRstuff
IRstuff

Part and Inventory Search

Sponsor

Back
Top