Need help setting up a simple simulation

[Aliyanarchi]

Ive been using solidworks for a few years now and recently got the solidworks simulation. I design wheels and i want to simulate a load on the wheel as if it were on a vehicle. I can get it to where there is a load around the whole outer area of the wheel but i just want it to be on one point, as if it were sitting on the road. any help?

 

[jodyjw]

You probably need to use split face to create a smaller face for the load.


Hope this helps.

 

[zhangc123]

Shins put together with calves can pull a lot interest to faster thighs, for that reason determine on