Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

need a high speed clutch

Status
Not open for further replies.
BobM2

BobM2

Mechanical
Dec 16, 2003
60
I'm looking for a high speed (25,000 RPM) clutch that can handle 4 in# torque. Operation would be full on or full off. Anybody know of any out there?
 
Status
Not open for further replies.

Similar threads

edison123
  • Question
Power Needed to Rotate a Mass to a Speed in a Specified Time 5
Replies
19
Views
5K
edison123
edison123
D
I need a Class 1 division 1 approved cable gland for both USA and Canada. And at the end of the cable there is a Molex connector.
Replies
0
Views
973
denuwan
D
lucky-guesser
  • Locked
  • Question
Clutch material
Replies
6
Views
281
lucky-guesser
lucky-guesser
Norse1957
  • Locked
  • Question
Just need to vent off a little steam... 1
Replies
3
Views
311
CWB1
CWB1
T
  • Question
Designing a Cooling System with a Plate Heat Exchanger – Pump & Flow Control Advice Needed
Replies
2
Views
1K
thomx5
T

Part and Inventory Search

Sponsor

Back
Top Bottom