Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Need a diameter symbol on the inspection report?

Status
Not open for further replies.
SeasonLee

SeasonLee

Mechanical
Joined
Sep 15, 2008
Messages
918
Location
TW
Hi All:

This question posted in Drafting Standards, GD&T & Tolerance Analysis Forum, perhaps here is the right place for this question, in order to prevent duplicate the same question, you are welcome to view the link below, and thanks for your inputs in advance.

Thanks

Season
 
Status
Not open for further replies.

Similar threads

dogbural
  • Locked
  • Question Question
MMC to a diameter
Replies
2
Views
1K
3DDave
3DDave
ishtechmech
  • Question Question
PWHT MULTIPLE TIMES ON THE SAME JOINT OF SA335P91 MATERIAL
Replies
9
Views
20K
Dhurjati Sen
Dhurjati Sen
Bazinga
  • Locked
  • Question Question
Inspection Plugs on hot insulation
Replies
4
Views
517
0707
0707
O
  • Locked
  • Question Question
points to capture on a 3D measurement
Replies
4
Views
2K
IRstuff
IRstuff
ASIT859
  • Locked
  • Question Question
FARO Cam2 - Straight Slot Surface Datum A, Flat Surface Datum B Inspection?
Replies
0
Views
871
ASIT859
ASIT859

Part and Inventory Search

Sponsor

Back
Top