Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
navigate in NX
- Thread starter helperug
- Start date
If you are very skilled in using the Navigate function found under View- Operation, you can capture a video of the fly-through.
( difficult...)
If you have the correct license level of the Vis - Viewer, it's easier to do the fly-through.
I don't think the fly mode exist in the lowest level license, - ?
Another option, also quite difficult to set up as desired , is the View- options- navigate Options... where you can define "keyframes" in between which NX will interpolate the movement, or use a "trajectory curve" along which the camera will move.
This fly-through can be rendered into a video or screen dumped into a video.
The keyframes / trajectory curve method can be step by step edited into the desired fly path.
Regards,
Tomas
( difficult...)
If you have the correct license level of the Vis - Viewer, it's easier to do the fly-through.
I don't think the fly mode exist in the lowest level license, - ?
Another option, also quite difficult to set up as desired , is the View- options- navigate Options... where you can define "keyframes" in between which NX will interpolate the movement, or use a "trajectory curve" along which the camera will move.
This fly-through can be rendered into a video or screen dumped into a video.
The keyframes / trajectory curve method can be step by step edited into the desired fly path.
Regards,
Tomas
JohnRBaker
Mechanical
Here's an a couple of examples of the type of animation that can be produced in NX using the technique described by Toost:
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:
To an Engineer, the glass is twice as big as it needs to be.
- Thread starter
- #4
I remember i have answered this before,..
Regards,
Tomas
Regards,
Tomas
- Status
