bigheadted
Electrical
so i have a pc which ive been told mutiplexes its i/o i can see that the leds flash in seuence as it scans from card to card but what does this actually mean?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
multiplex
- Thread starter bigheadted
- Start date
- Status
Skogsgurra
Electrical
Is it a PC or a PLC? OK, that doesn't matter. I assume that you are talking about analogue inputs and that usually means having one analogue-to-digital converter. Good A/D converters are (or used to be) quite expensive, so using one for each channel is (was) considered a luxury that few can (could) afford.
So, a set of switches are used to connect one analogue input at a time to the A/D. A value is read from the A/D and the next channel switched to the A/D. It is this switching that got the name multiplexing.
The switches can be little relays (you will hear the switching, sounds like little animals moving inside a tin box) or they can be solid state (transistor, FET and CMOS) switches. They are quiet. Nothing can be heard.
Multiplexers typically switch 8 or 16 channels. Multiplexing can be quite fast if you have solid state switches and usually not faster than 10 or 20 channels/seconf if you have relay switches.
The cross-talk between channels is generally better with relays, but modern solid state switches are also very good.
Gunnar Englund
--------------------------------------
100 % recycled posting: Electrons, ideas, finger-tips have been used over and over again...
So, a set of switches are used to connect one analogue input at a time to the A/D. A value is read from the A/D and the next channel switched to the A/D. It is this switching that got the name multiplexing.
The switches can be little relays (you will hear the switching, sounds like little animals moving inside a tin box) or they can be solid state (transistor, FET and CMOS) switches. They are quiet. Nothing can be heard.
Multiplexers typically switch 8 or 16 channels. Multiplexing can be quite fast if you have solid state switches and usually not faster than 10 or 20 channels/seconf if you have relay switches.
The cross-talk between channels is generally better with relays, but modern solid state switches are also very good.
Gunnar Englund
--------------------------------------
100 % recycled posting: Electrons, ideas, finger-tips have been used over and over again...
- Status