plasticguy78
Mechanical
Does anyone have any experience with any good 2-shot or insert injection molders overseas that are inexpensive processors?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
multi-shot molder
- Thread starter plasticguy78
- Start date
- Status
TheAnswerGuy
Materials
plasticguy78,
Yes I do!
They are in Maylasia and China.
But I am sure that you will get many other responses to this question as well.
Yes I do!
They are in Maylasia and China.
But I am sure that you will get many other responses to this question as well.
- Thread starter
- #3
Dear Plasticguy,
I am based in Bangkok Thailand and have 3 x 2 shot Nissei 120 ton machines with full capacity available. The machines are parallel configuration and the moving platen utalizes a turntable. Previously we were producing PC + EPDM PCB mounting rails for Dell, however due to a corparte policy change the moulds have been shipped to China. We also have full tool making capabily.
If you would like to contact me please do so by e.mail chaving@yahoo.com
I look forward to hearing from you
I am based in Bangkok Thailand and have 3 x 2 shot Nissei 120 ton machines with full capacity available. The machines are parallel configuration and the moving platen utalizes a turntable. Previously we were producing PC + EPDM PCB mounting rails for Dell, however due to a corparte policy change the moulds have been shipped to China. We also have full tool making capabily.
If you would like to contact me please do so by e.mail chaving@yahoo.com
I look forward to hearing from you
- Status
Similar threads
- Locked
- Question