We are trying to machine a 4"x7" tapered shim out of 7075 T76 .063 CLAD material. We haven't been able to locate any MRS/LRS material, and the non-stress relieved material warps during machining. We are trying to taper from .063 to .015. Does anyone have any suggestions for machine feeds and speeds, tooling? Any help greatly appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
MRS/LRS Tapered Shim Machining
- Thread starter idokie
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
