Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Moving views in MDT5 to new layouts
- Thread starter edi
- Start date
I haven't got MDT5 yet, but in MDT4 I only know of two ways.
1) place the base view you want to take the section view from outside the paper area, so therefore that view is hidden when you plot and the section view updates as you make changes.
2) use the "amviewout" command to capture the particular section viewport you want and then import or place this *.dwg block into the appropriate view. It is of course disasociated now with the design and does not update.
You may be able to place the base view on another layer and then hide it/not print it - don't know not tried
regards
Andy M
1) place the base view you want to take the section view from outside the paper area, so therefore that view is hidden when you plot and the section view updates as you make changes.
2) use the "amviewout" command to capture the particular section viewport you want and then import or place this *.dwg block into the appropriate view. It is of course disasociated now with the design and does not update.
You may be able to place the base view on another layer and then hide it/not print it - don't know not tried
regards
Andy M
- Status
Similar threads
