Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

motion simulation

Status
Not open for further replies.

mk2coupe

Mechanical
Joined
Nov 3, 2009
Messages
1
Location
CA
hello,
i wanted to create a pin-in-slot joint in motion simulation for NX6. I tried to make the pin centre a slider on the slot ocntre line, but that gives me an error when i try solving it. Any tips would be appreciated please.
Thanks
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top