zif63
Electrical
- May 21, 2013
- 5
Hi All,
I've been asked to change several parameters on a system that consists of nine MOSCAD-L CPUs, originally commissioned 1999. They are all installed in two side by side cabinets. Since 2003. there have been no program changes.
I hope these parameters are accessible over operator interfaces, there is one per each CPU. If not, then I have to use ToolBox 9.5. Also, I've found information about uploading and downloading the program (download requires password to be entered, most likely nobody knows it) to MOSCAD-L CPU.
Is there any way I can only go on-line and change it, or upload and download are my only options here?
Thanks!
I've been asked to change several parameters on a system that consists of nine MOSCAD-L CPUs, originally commissioned 1999. They are all installed in two side by side cabinets. Since 2003. there have been no program changes.
I hope these parameters are accessible over operator interfaces, there is one per each CPU. If not, then I have to use ToolBox 9.5. Also, I've found information about uploading and downloading the program (download requires password to be entered, most likely nobody knows it) to MOSCAD-L CPU.
Is there any way I can only go on-line and change it, or upload and download are my only options here?
Thanks!
