My company uses a MV Jr (with carbide inserts on our bits)to drill holes through flanges. Previous engineers at the company programmed it to drill only carbon steel, and I am trying to progam it for 304/L stainless. The way I understand it stainless is to be drilled at a lower rpm. Can anyone recommend a starting rpm and feed rate that I should run it at?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mori-Seiki MV Jr Clueless
- Thread starter jcmech
- Start date
MikeHalloran
Mechanical
The application engineer for the carbide insert company lives to help you.
Mike Halloran
Pembroke Pines, FL, USA
Mike Halloran
Pembroke Pines, FL, USA
- Status
Similar threads