Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

modeling of Ribbons coated with Cu-Ni

Status
Not open for further replies.
redwanamit034

redwanamit034

Mechanical
Joined
Mar 10, 2013
Messages
19
Location
US
I need to model sintering of Fe based amorphous ribbons coated with Cu/Ni . The ribbon is about 25 micron and coatings are 5-10 micron. There will be 20 layers of this ribbon coated with Cu/Ni stacked together. What type of element should I use for ribbons and coating?
 
Status
Not open for further replies.

Similar threads

M
  • Question Question
FEA Adhesive Modeling
Replies
3
Views
5K
milio000
M
G
  • Question Question
FEA Simulation of a Piezoelectric Accelerometer with Frequency Response Analysis
Replies
2
Views
9K
gnana_235
G
vanji1
  • Locked
  • Question Question
If I want to construct myself a geometric stiffness matrix induced by a pre constraint with finite element modeling
Replies
0
Views
1K
vanji1
vanji1
A
  • Question Question
Problem fusing cone with curved geometry in Salomé-Méca (GEOM module)
Replies
0
Views
6K
Aliénor
A
EdwardNigma
  • Locked
  • Question Question
Mastering FEA: How to Get Through Stage 2 (Developing Good Modeling Techniques)?
Replies
7
Views
4K
rb1957
rb1957

Part and Inventory Search

Sponsor

Back
Top