Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Model breaded metal hoses in Caesar II 1
- Thread starter carlino
- Start date
-
1
- #2
You don't - CAESAR II models "pipes" using the "3D Beam" element. This element is not sufficient to model flexible hose. In addition, the stiffness of the hose is so much less than that of the pipe, the pipe sees the transition point as a free end.
Richard Ay
Intergraph CAS
Richard Ay
Intergraph CAS
pipesnpumps
Mechanical
Man, I dough not know what you guys are talking about, but not sure I knead too anyway.
Real world knowledge doesn't fall out of the sky on a parachute, but rather is gained in small increments during moments of panic or curiosity.
pipesnpumps,
I just wanted to "raise" a question as I had not heard of a "Breaded Metal hose" and thought it may be similar to a "croissant" but C2it corrected my mistake and put me right with it being a Flanged baguette. It's always worth asking at "yeast" you get the right answer from somewhere!!
I just wanted to "raise" a question as I had not heard of a "Breaded Metal hose" and thought it may be similar to a "croissant" but C2it corrected my mistake and put me right with it being a Flanged baguette. It's always worth asking at "yeast" you get the right answer from somewhere!!
- Status
Similar threads
- Question
