Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
mixing condenser process equipment design
- Thread starter gelsi
- Start date
Hey gelsi,
A pump around system is a pretty simple process design. The heat duty (condensation rate) will set the pump around flow for a design delta-T on the liquid. Then it is mostly an exchanger design problem. A process simulator can do this calculation in a few minutes. On the contacting side you can get some advice from a tower vendor on the best spray system to use based on your calculated flows.
Maybe you can find something useful here:
Best wishes,
Sshep
A pump around system is a pretty simple process design. The heat duty (condensation rate) will set the pump around flow for a design delta-T on the liquid. Then it is mostly an exchanger design problem. A process simulator can do this calculation in a few minutes. On the contacting side you can get some advice from a tower vendor on the best spray system to use based on your calculated flows.
Maybe you can find something useful here:
Best wishes,
Sshep
- Status
Similar threads
