Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Minimum width of closed tie fitment

Status
Not open for further replies.
pizzalover

pizzalover

Structural
Joined
Aug 3, 2022
Messages
6
Location
AU
Hi there,

I have checked AS3600 but still not sure about what the minimum width of closed fitment in a beam can be.
AS3600 specifies internal diameter of the bend of D500N bar is 4db.
So should the min width be 2*bar size + 2db + 2db?
does it require a straight section between the bend?
Thanks
 

Attachments

  • IMG_9681.jpeg
    IMG_9681.jpeg
    1.3 MB · Views: 2
Status
Not open for further replies.

Similar threads

S
  • Locked
  • Question Question
What are some best practices for improving the efficiency of heat transfer in a closed-loop cooling system
Replies
1
Views
977
LittleInch
LittleInch
abaqus_beginner
  • Locked
  • Question Question
ABAQUS TIE CONSTRAINTS
Replies
1
Views
282
FEA way
FEA way
Kyu Kyu Lwin
  • Locked
  • Question Question
Etabs v21.01 results for RC beam minimum rebar
Replies
0
Views
1K
Kyu Kyu Lwin
Kyu Kyu Lwin
k0330
  • Locked
  • Question Question
Measure the area of closed curves in Siemens NX
Replies
6
Views
631
rb1957
rb1957
k0330
  • Locked
  • Question Question
How to determine the width of a beam waist in laser cutting?
Replies
0
Views
201
k0330
k0330

Part and Inventory Search

Sponsor

Back
Top