Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

MIL-standard for Rotary seal selection

Status
Not open for further replies.
thought2007

thought2007

Aerospace
Joined
Sep 14, 2006
Messages
43
Location
IN
Is MIL-G-5514 is used for selection of rotary seals
However this standard refer only for static seal selection

Is there any other standard available for selection of rotary(dynamic) seal
 
Status
Not open for further replies.

Similar threads

WKTaylor
  • Locked
  • Question Question
A few of the Regulations for Civil Spaceflight
Replies
2
Views
4K
WKTaylor
WKTaylor
G
  • Question Question
How to find the position of the joint axis for Eccentrically Loaded Joints in ECSS-E-HB-32-23A
Replies
4
Views
5K
WKTaylor
WKTaylor
WKTaylor
  • Locked
  • News News
How Do You Deliver a 7,000-Pound Spacecraft... to the KSC in-prep for Launch...
Replies
0
Views
5K
WKTaylor
WKTaylor
WKTaylor
  • Locked
  • Question Question
SpaceX Super Heavy rocket gets supersonic wind tunnel test for NASA's Artemis moon missions (photos)
Replies
12
Views
7K
WKTaylor
WKTaylor
Ionut Cosmin
  • Locked
  • Question Question
How to determine the environmental loads for a CubeSat based on the launcher?
Replies
2
Views
5K
rb1957
rb1957

Part and Inventory Search

Sponsor

Back
Top