Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

metric parts in inch assemblies

Status
Not open for further replies.
hdaven

hdaven

Mechanical
Joined
Feb 20, 2002
Messages
15
Location
US
I deal with a lot of metric parts and inch assemblies. Is there a way to have a part sub-assembly xreffed (using the amcatalog) into an inch assembly without have to scale the metric part down to inches?

Thank you,
Havis
 
Status
Not open for further replies.

Similar threads

Edscad
  • Locked
  • Question Question
Mass Properties in BOM
Replies
0
Views
715
Edscad
Edscad
Mechduff
  • Locked
  • Question Question
Reference dims in drawing mode will not scale
Replies
0
Views
751
Mechduff
Mechduff
skimmerman
  • Locked
  • Question Question
Opening drawing in Mechanical Desktop
Replies
1
Views
766
5177
5177
tbug
  • Locked
  • Question Question
Autodesk Inventor 2011
Replies
1
Views
742
rollupswx
rollupswx
Dudyone
  • Locked
  • Question Question
Turning drawing into solid.
Replies
0
Views
669
Dudyone
Dudyone

Part and Inventory Search

Sponsor

Back
Top