Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Metalsoft/Trumpf

Status
Not open for further replies.
heftifab

heftifab

Mechanical
Oct 10, 2007
1
I'm running metalsoft V11 and have a trumpf Tc2000, my question is about drill and tap tools and how to create and use them on the trumpf. I seem to run into a road block when asking metalsoft or trumpf about it. Any input would be helpfull.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom