polaris7eng
Mechanical
Hello
I need to make meshes connection only on a part of the flat surface.
On part No. 1, I have a division of the surface.
One section of the divided surface is to be taken from section 2 (mesh merge)
Does anyone have experience with such a mesh preparation?
I do not want to model the micro cut-outs, this solution is not good. This model is simple. In the target model, the cut-out operation is too complicated (free surface modeling).
I need to make meshes connection only on a part of the flat surface.
On part No. 1, I have a division of the surface.
One section of the divided surface is to be taken from section 2 (mesh merge)
Does anyone have experience with such a mesh preparation?
I do not want to model the micro cut-outs, this solution is not good. This model is simple. In the target model, the cut-out operation is too complicated (free surface modeling).
